Trunk / PRI / Connectivity FAQ's
- What Trunk Start Signaling Type does Allworx use? [click here]
-
When using CAS/RBS, Allworx handles Wink (Feature Group B only ), Immediate, Loop, and Ground Start trunks.
Note: E&M Wink Start - Feature Group D (Wink Start with Wink Acknowledge protocol), is not supported.
- What is the Incoming trunk selection sequence? [click here]
- Allworx handles ascending and descending selection only.
- Does Allworx handle PBX Store & Route Digits? [click here]
- Allworx handles from 1 digit to the full number. The most common setting for DID's is 4 digits (FYI, "store and forward" is used with RBS, not PRI).
- What is the Phone Switch Type? [click here]
- Allworx IP PBX.
- What PRI Types are used? [click here]
-
Allworx handles:
- NI-2
- DMS100 proprietary
- Lucent 4E & 5E proprietary
- How do you set up Return Dialtone on Seizure? [click here]
- Allworx will do this ourselves, please don't set the switch up to provide that setting.
- Who sets up Yield to Glare? [click here]
-
Both sides may/can do that.